用GC2000转换CAD档

,按一下以編輯母片標題樣式,按一下以編輯母片文字樣式,第二層,第三層,第四層,第五層,*,Inventec,Confidential,*,GC2000,导,CAD,File,Import,选择,gerber,档导入,1.,导入,gerber,档,OK,OK,确定，,gerber,导入,OK,1.,导入,gerber,档,鼠标右键，选择,Select All,，,layer,变成白色,2.,设定原点,(,将,GC2000,白框左下角和,gerber,左下角重叠,),鼠标停在,layer,的左下角,Z,2.,设定原点,(,将,GC2000,白框左下角和,gerber,左下角重叠,),鼠标移动到,GC2000,白框左下角,OOK,2.,设定原点,(,将,GC2000,白框左下角和,gerber,左下角重叠,),白框移动到,layer,左下角，接下去进行微调,2.,设定原点,(,将,GC2000,白框左下角和,gerber,左下角重叠,),2.,设定原点,(,将,GC2000,白框左下角和,gerber,左下角重叠,),先调,X,轴，鼠标停在,layer,框上,SZ,空格,2.,设定原点,(,将,GC2000,白框左下角和,gerber,左下角重叠,),鼠标停在白框上,点,O,出现的对话框中将,Y,改成,0OK,2.,设定原点,(,将,GC2000,白框左下角和,gerber,左下角重叠,),调整,Y,轴，动作参考,X,轴,2.,设定原点,(,将,GC2000,白框左下角和,gerber,左下角重叠,),原点设定,OK,3.,导入原始,CAD,档,File,Load,CAD,Centroids,选择导入的,CAD,档,OK,3.,导入原始,CAD,档,如图设定后,OK,分隔符,单位,标题行,Location,X,坐标,Y,坐标,角度,区分,AB,面,3.,导入原始,CAD,档,No errors,found,OK,3.,导入原始,CAD,档,粉色是,B,面的位置，点右键选,hide,将其隐藏,4.,将原始,CAD,和,gerber,重合,将,A,面,CAD,全选，鼠标右键出现菜单中选择,Select All,变成白色,点,REF,，出现,location,（如图）,点,gerber,层，右键选择,view,4.,将原始,CAD,和,gerber,重合,P,在对话框中输入,MARK1SZ,空格,4.,将原始,CAD,和,gerber,重合,鼠标停在,mark1,对应,Gerber,上的,PAD,SOOK,4.,将原始,CAD,和,gerber,重合,如图所示，,CAD,和,gerber,重合完成,4.,将原始,CAD,和,gerber,重合,Q,Save,给新,CAD,命名,储存,5.,导出,CAD,档,保存的,CAD,如图所示,5.,导出,CAD,档,Thank You,Question and Answer,