高氯化聚乙烯底漆

高氯化聚乙烯底漆Intended Uses用途专用于混凝土或钢结构设施表面涂装底漆，有优良的耐碱性能，对混凝土底材有很强的渗透性和封闭性，漆膜附着力强、干燥快、施工方便。Especially used for protecting surface of concrete or steel installations as primer. It forms a coating with excellent resistance to alkali, high penetrability and sealing. High adhesion, quick dry and easy application. ProductDescription产品简介有铁红，浅灰等色。Iron red, light grey, etc.ProductInformation产品数据Volume Solids 体积固体份35%Dry Film Thickness 干膜厚度35-40 microns equivalent to 100-115 microns of wet film35-40微米相当于100-115微米湿膜厚Theoretical Coverage 理论涂布率8-10m2/Kg 8-10平方米/公斤Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗Application Details施工详述Mix Radio 混合比One pack 单罐装Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Recommended 推荐采用 Conventional Spray 传统喷涂 Recommended 推荐使用 Thinner 稀释剂 C001Cleaner 油漆设备清洗剂 C001Pot Life 使用期 Not limit 不限制Storage 贮存期 One year 一年Drying time 干燥时间SubstrateTemperature底材温度,Touch Dry表干（h）Hard Dry硬干(H）Over coating Interval覆涂间隔Mix最短Max最长1025 35 12424 h8 h6 h 7 dStorage andHandling贮存与管理Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 25Kg in 20 liter container 25公斤装于20公升容器中Flash Point 闪点 38 Specific Gravity 比重 Approx 1.25Kg/L 1.25公斤/公升Specification and Surface preparation技术要求及表面处理Steel surface: clean to Swedish Sa2.5 or rust-removed manually or with power tool to Swedish Standard St3. Concrete surface: Remove oil, grease and dust etc, prior to application钢材表面：喷射除锈至瑞典标准2.5级或手工除锈或动力工具除锈达瑞典St3级混凝土表面：除去表面油脂，灰尘等Limitations限制Subsequent coat: Highly chlorinated polyethylene anti-corrosive finish with all colors后道配套涂料：各色高氯化聚乙烯面漆Safety Precautions 安全措施The product must be used in painting area by professionals. When painting, please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying the product.The product is a kind of solvent-based paint. In order to avoid the accident or dangerous occurrence, minimal safety precaution, as follow, should be down.The paint contains volatile solvent and it is flammable, So must keep away from sparks and open flames. No smoking at workplace, Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid product sparks. Enough ventilation is necessary at application sites. In order to remove any danger of explosion, must keep the ratio of gas / air is less than 10 %, Usually 200 m3of ventilation quantity per 1 Kg solvent (according to the solvent) is necessary, it canMaintain the minimum explosive limit. Take effective precautions to prevent skin and eye contact with the coating (such as the use of overalls, gloves, goggles, face shields and protective oil coating and so on). If paint gets in touch with skin,If accidental skin contact with the product, please use fresh water and soap or an appropriate industrial cleaning agents thoroughly cleansed. In case of eyes being contaminated, rinse with fresh water for 10 min at least and give medical treatment immediately.During painting, it is recommended to wear face shields to prevent inhalation of paint mist and harmful gases.Especially in poorly ventilated environment, it is more necessary.Finally, be handled with care so as not to waste paint barrels of pollution of the environment.NOTICE: If consumers have not taken effective safety precautions (Refer to the specification), our company will NOT be responsible for any accident. 本产品必须由专业人员在工业场所使用。使用时请务必参照本说明书以及相关健康安全手册。若客户在使用本产品前,未能详细了解本产品的相关健康安全知识,请与本公司人员联系。该涂料为溶剂型涂料，为避免事故或危险发生，应采取最低限度的安全措施如下：此涂料为易燃物,并含有挥发性易燃溶剂，故必须远离火星和明火。严禁在作业场所吸烟，并应该采取有效措施，防止火星产生(如采用防爆电器设备，杜绝静电积累,避免金属撞击等)。 施工场所应尽量保持良好通风。为消除使用过程中的爆炸隐患,应保证足够的通风量以维持气体/空气比例不超过最低爆炸极限的10 %,通常每千克溶剂需要200立方米通风量,(与溶剂种类相关)就能维持最低爆炸极限10 %的工作环境。 采取有效措施，防止皮肤和眼睛与涂料直接接触(如使用工作服,手套,护目镜,面罩及涂防护油等)。若皮肤不慎与产品相接触,请用清水及肥皂或适当的工业清洁剂彻底清洗；若眼睛受到污染,请即刻用清水冲洗至少10分钟,并立即就医。在施工时，建议佩戴面罩以免吸入漆雾和有害气体，尤其在通风不良的环境下，更要注意。最后请谨慎处理废旧漆桶以免污染环境。 责任声明：对于未按本公司所要求采取有效得安全措施而引起的安全事故,本公司不负任何责任。来源：